Electromechanical Testing

• SSR & Mechanical Relays

• Stepper & Servo Drivers, and Motors

• HMI (Touchscreen Interface not shown)

• Multiple Inputs (Buttons & Switches)

• Multiple Outputs (Indicator Lights)

• I started printing in 2015.  Primarily in FDM (Fused Deposition Modeling) Utilizing common 1.75mm PLA, ABS and similar filaments. Later with SLA (Stereolithography) utilizing UV lasers in polymerization of reactive resins.  

• I've modified machines replacing hardware and recoding firmware's (Marlin, Sailfish, Smoothieboard). For professional systems, manipulated Stratasys systems to use aftermarket filament for ~90% cost reduction. (Stratasys EEPROM hack revisted – Have Blue [dot org])

• My passion was in learning of the mechanics of motion, and it provided a quick introduction ACME thread, Leadscrews, Ballscrews, metered rotation, tolerances and loss in backlash. As well as feeling the friction in linear rails, rods, and carriages. 

Simple circuit design for continuity testing of firing circuit without accidental ignition. 

• Enclosed in .50cal ammunition container

• Built-in power supply & charging port. 

• Multiple independent, isolated terminal/binding ports.

• Diagnosed and replaced ABS Control Unit F32 

• Service Indicator Lamp Reset Tool - E36

OEM Plastic Injection Molded

• Button Back Plate

• Button Cover Plate

• Button Mounting Base